Beginner Guide
The number one reason women hesitate to buy their first luxury wig is not price. It is fear — that it will not look natural, that they will not know how to put it on correctly. With the right technique, a glueless HD lace wig can be installed at home, look completely natural, and stay secure without adhesive.
The AA WIGS Signature Body Wave — natural hairline, front-facing, lace blended and styled.
A glueless wig is designed to be worn without glue, tape, or bonding adhesive. Instead of chemical attachment, it uses three structural elements for security:
The AA WIGS Signature Piece is glueless-ready out of the box. No additional tools, adhesives, or salon appointments required.
AA WIGS Tip: Good lighting is essential during installation, particularly for lace trimming. Natural daylight gives you the most accurate view of where the lace ends and your skin begins.
Flat braid your natural hair in a cornrow pattern, working toward the back of your head. For very short or fine hair, a stocking cap can be used instead. The goal is a smooth, flat foundation with no bumps that would show through the wig. The flatter the base, the more natural the installation sits.
Flat braid preparation — side view, natural hair prepped and smooth.
Hold the wig at the front two corners of the lace. Tilt your head slightly forward. Place the front of the wig at your natural hairline — not above it, not below it. Directly at it. Slide the wig back gently until the lace sits flush against your forehead. Your natural hairline should sit just beneath the lace.
Reach to the back and tighten the adjustable drawstring band until the wig sits firmly on your head without pulling or tension. It should feel secure — not tight. Secure the front combs by pressing them gently into the hair at your temples. Clip the nape comb into the hair at the back. One or two bobby pins along the perimeter can add extra hold if needed.
Securing the wig — back three-quarter view showing the adjustable band and ear tabs in position.
Using small, sharp scissors, trim the excess lace as close to the hairline as possible. Cut in small sections, following the natural curve of your hairline. Take your time with this step — it makes the difference between a natural and obvious install. Once trimmed, apply a small amount of edge control along the perimeter and use a soft brush to press the lace flat. Wrap your hairline with a silk scarf for 5–10 minutes to allow the lace to mold to your skin.
AA WIGS Tip: Cut lace in good lighting. Natural daylight is best. Small, precise cuts are always better than one long cut — it is far easier to remove a little more than to correct too much.
Remove the scarf. The lace should now sit flush with no visible edge. Part the hair using the end of a comb, apply any desired product, and style the body wave to your preference. The 13×6 lace frontal gives you full ear-to-ear parting space — enough for a deep side part, a centre part, or a pulled-back style.
Final styled result — front-facing, natural hairline fully blended, body wave styled.
Have questions about your installation? The AA WIGS Concierge is available to guide you through every step.
Contact the AA WIGS Team →Yes. A glueless wig is the most beginner-friendly option available. The AA WIGS signature piece uses an adjustable drawstring band and built-in combs — no adhesive required. The most important skill is lace trimming, which improves significantly with practice.
Yes. Trimming the excess lace is an essential step that determines how natural the hairline appears. Cut close to the hairline in small sections using sharp scissors — never in one long pass. This single step is the primary difference between a detectable and an undetectable install.
A correctly-fitted glueless wig held with the adjustable band, front combs, and nape comb should remain secure during normal wear. If slipping occurs, check that the drawstring is fully tightened and all combs are pressed firmly into the hair beneath. Bobby pins along the perimeter add security for more active wear.
Wrapping the hairline for 5–10 minutes after applying edge control allows the lace to mold to the shape of your scalp and forehead. Without this step, the lace can lift at the edges. It is the step most beginners skip — and the one that most significantly affects the final result.
Yes. The adjustable drawstring band, built-in combs, and elastic ear tabs provide a secure, all-day fit without glue or tape. The 13×6 Swiss HD lace creates a natural hairline on its own. No additional tools and no salon appointment are required.
For more care and maintenance guidance, visit the AA WIGS Care Guide or speak with the Concierge directly via @aawigshair.
The AA WIGS Concierge is here to help. Reach us directly for personalized guidance on installation, care, or anything else.
Contact the Concierge →Explore More from AA WIGS